If your Mazda 6 was produced from Nov. 2003 to Sep. 2005, chances are that the Head Unit cannot recognize YATOUR.This is because newer Head Units do not have the zero ohm register on the PCB location L716. To solve this problem, you must take the Head Unit out, open Head Unit (it voids warranty) and solder a Jumper or a 0-ohm chip register on location L716.
view allProduct List
Latest Add
Contact Us
Room 813, Yongyi Xindu , No.8 Yongfu Road, Yuexiu District, Guangzhou 510500 CHINA
Mr.Vincent Xie WeChat: vincentxie1985
86-20-83581190
86-20-83581216
8613450236562
Products
-
Mazda 6 Internal Modification for YT-M05 and YT-M06
-
Connection Guidance of Audi 20-Pin Block Adapter CableA separate 20-pin Block Adapter Cable is designed for Audi car stereos (mini ISO 8 pin), the Adapter Cable works together with mini ISO 8-pin cable
-
HOW TO check firmware version in Mazda RX8To get your firmware version of your Mazda RX8, push and hold the TEXT button and then at the SAME TIME push the number 1 button on the stereo and hold . and make sure you are in FM mode. If you do it right it will tell you your Firmware. If you do it wrong it will say CLEAR.
-
Yatour Special Notice for BMW with CD Changer and BMW DSPFor BMW with original CD Changer, it is required to disconnect the original CD Changer(3Pin+6Pin connection in the trunk) before you install YATOUR
-
How can I know whether my BMW is with DSP or not?How can I know whether my BMW is with DSP or not?